2020-03-02

Cable - Latch - Hood - LH (Dual Motor) (Remove and Replace)

Correction Code 11356502

Removal

  1. Remove the underhood storage unit (refer to procedure).
  2. Release the rear cable from the latch assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    If performing this procedure on the RH side, release the front cable.
  3. Release the clip that secures the cable to the front carrier.
  4. Release the clip that secures the cable spring assembly to the front carrier.
    Informational PurposesAn informational icon, calling your attention
    Note
    The RH actuator does not have a cable spring assembly.
  5. Release the cable from the cable abutment bracket.
  6. Release the cable from the actuator.
  7. Remove the cable from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:
Informational PurposesAn informational icon, calling your attention
Note
Ensure that the hood functions properly.
  1. Install the clip that secures the front carrier approximately 20 mm outboard of the hole in the front of the carrier.