20/01/2023 13:03:14

Ballast - HID - LH (SAE) (Remove and Replace)

Correction Code 17400232

Removal

  1. Remove the LH front wheel arch liner louver. See Louver - Wheel Arch Liner - Front - LH (Remove and Replace).
  2. Peel back the front of the LH wheel arch liner to gain access to the headlight assembly.
  3. Remove the screws (x3) that attach the HID ballast to the headlight assembly.
  4. Disconnect the electrical connectors (x2) from the HID ballast.
    Informational PurposesAn informational icon, calling your attention
    Note
    If corrosion on the connectors is observed, the headlight may need replacement; refer to Toolbox article 54602.

Installation

  1. Clean the ballast mounting area on the headlight with a towel.
  2. Connect the electrical connectors (x2) on the HID ballast.
  3. Install the screws (x3) that attach the HID ballast to the headlight assembly (torque 4 Nm).
  4. Move the front of the LH wheel arch liner back into position.
  5. Install the LH front wheel arch liner louver and all other components that were removed for access. See Louver - Wheel Arch Liner - Front - LH (Remove and Replace).