02/03/2020 13:50:14

Window Regulator - Front - LH - Recalibrate

Correction Code 11502000

Informational PurposesAn informational icon, calling your attention
Note
Perform both the De-Calibration and Calibration sections of this procedure.

De-Calibration

  1. Repeatedly activate auto-reverse on the affected window:
    1. Open the door that has the affected window.
    2. Fully lower the window.
    3. Enter the vehicle and close the door.
    4. Hold a non-marring tool below the upper window seal. Raise the window so that it contacts the tool and automatically reverses.
    5. Repeat the previous sub-step 14 times.

Calibration

Informational PurposesAn informational icon, calling your attention
Note
Perform the steps in the De-Calibration section before continuing.
  1. Enter the vehicle and close the door.
  2. Lower the window fully, and continue to hold the window switch down for 2 seconds after the window stops.
  3. Raise the window fully, and continue to hold the window switch up for 5 seconds after the window stops.
  4. Press the window switch down to the second position to activate the auto-lower function.
    • If the window lowers completely, the regulator is properly calibrated. Discontinue this procedure.
    • If the window does not lower completely, repeat the De-Calibration procedure, then perform the Calibration procedure again.