02/03/2020 13:50:14

Brake Lines - Booster to ABS (Dual Motor) (RHD) (Remove and Replace)

Correction Code 33034502

Removal

  1. Recover the A/C refrigerant from the vehicle (refer to procedure).
  2. Remove the 12V battery bracket beam (refer to procedure).
  3. Release the fasteners (x2) that secure the fuse box to the front crossmember (torque 6 Nm).
  4. Release the clip that secures the wheel speed sensor harness, then remove the nut that secures the high pressure A/C pipe to the body.
  5. Release the bolts (x4) that secure the coolant reservoir to the front crossmember (torque 6 Nm). Do not remove the reservoir at this time.
  6. Carefully lift up the coolant reservoir and disconnect the coolant level sensor harness.
  7. Release all clips that secure the coolant hose to the bottom of the front crossmember.
  8. Release the clip that secures the RH body harness to the bottom of the front crossmember.
  9. Release the nut that secures the front drive unit ground stap to the body (torque 6 Nm), then release the clip that secures the intelligent battery sensor (IBS) harness to the body.
  10. Release the clip that secures the 4-way valve hose to the body.
  11. Disconnect the harness from coolant pump 1, then slide the pump outboard to remove it from the subframe. Move the pump out of the way to gain acccess to the brake lines.
    Informational PurposesAn informational icon, calling your attention
    Note
    The coolant hoses do not need to be disconnected from the pump.
  12. Remove the bolt that secures the A/C pipe bracket to the cross-brace (torque 6 Nm).
  13. Remove the bolts (x2) that secrure the TXV to evaporator (torque 6 Nm).
  14. Remove the nut that secures the high pressure A/C pipe to the compressor (torque 10 Nm). Release the pipe and remove the seal. Plug the hole.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The hole must be plugged to prevent contamination.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Remove and discard O-rings.
  15. Remove the brake fluid from the reservoir.
  16. Release the clips (x3) that secure the brake lines to the LH frame rail.
  17. Release the clips (x2) that secure the brake lines to the front crossmember.
  18. Place suitable absorbent material underneath the ABS module and brake lines.
  19. Release the front brake lines from the ABS module (torque 23 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If brake fluid is spilled on a painted surface, wash off immediately with clean water.
  20. Plug the brake line connections to prevent contamination.
  21. Place suitable absorbent material underneath the booster and brake lines.
  22. Release the front brake lines from the booster (torque 18 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If brake fluid is spilled on a painted surface, wash off immediately with clean water.
  23. Plug the brake line connections to prevent ingress of moisture or dirt.
  24. Remove the brake line bundle from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following: