23/10/2024 06:42:58

Module - Autopilot - ECU (Dispose)

Correction code 17155007 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
This procedure must be performed prior to disposing of an Autopilot ECU. The Autopilot ECU might contain personally identifying Customer data. Failure to perform this procedure can result in vulnerabilities to Customer and Tesla internal information.
Informational PurposesAn informational icon, calling your attention
Note
The correction code for the disposal of the Autopilot ECU must be added to the Service Visit as a separate activity when replacing a car computer.

Disposal Procedure (HW2.X Autopilot ECU)

  1. Remove the screws (x4) that attaches the top cover of the Autopilot ECU.
  2. Remove the screws (x10) that retain the APE PCBA to the housing, and then disconnect the connectors (x2) from the PCBA.
  3. Remove the PCBA from the housing.
  4. Flip the PCBA over, and then remove the bolts (x12) that attach the heatsinks to the PCBA.
  5. Use an 8mm drill bit to drill holes (x4) through the APE CPUs and UFS chips and through the PCBA.
    Informational PurposesAn informational icon, calling your attention
    Note
    Place a block of wood or other buffer material under the PCBA.
  6. Capture images of the drilled out chips, and upload the images to the MRB attachment section.
  7. Dispose of the Autopilot ECU.
    Informational PurposesAn informational icon, calling your attention
    Note
    Follow local laws and regulations for waste disposal.

Disposal Procedure (HW3.X Autopilot ECU)

  1. Remove the screws (x4) that attaches the top cover of the Autopilot ECU.
  2. Remove the screws (x16) that retain the APE PCBA to the housing, and then disconnect the connectors (x2) from the PCBA.
  3. Remove the PCBA from the housing, and then flip the PCBA over to expose the APE CPUs and UFS chips.
  4. Flip the APE PCBA board over, and then use an 8 mm drill bit to drill holes (x4) in the APE CPUs and UFS chips and through the PCBA.
    Informational PurposesAn informational icon, calling your attention
    Note
    Place a block of wood or other buffer material under the PCBA.
  5. Capture images of the drilled out chips, and upload the images to the MRB attachment section.
  6. Dispose of the Autopilot ECU.
    Informational PurposesAn informational icon, calling your attention
    Note
    Follow local laws and regulations for waste disposal.