23/11/2022 09:41:58
Nozzle - Windshield Washer (Adjust)
Correction code 17501300
Warning
This procedure is a DRAFT,
although it has been validated. Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near high voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
- Open LH front door
- Lower LH front window
-
Activate windshield washers and verify washer nozzle spray pattern
-
Confirm the jets sprayed in the green zone.
NoteIf the jet spray is on-target, discontinue this procedure. If the spray is off-target, continue to the next step.
-
Using a straight pick, adjust the washer nozzles.
NoteAlign the washer jet angle to between the middle of the windshield and 15 mm above the black border of dots (frit) along the bottom of the windshield (11 degrees +/- 1 degree).
-
Activate windshield washers and verify washer nozzle spray pattern
-
Raise LH front window and close door