07/04/2022 16:08:15

Glare Shield - 2nd Generation Autopilot (Remove and Replace)

Correction Code 15052502

Part Number Description
1080559-20-A Adjustable Torque Vario Screwdriver (0.8 - 2.0 Nm)
1071339-00-A Adapter, bit holder, 1/4 in

Removal

  1. Remove the rear view mirror (refer to procedure).
  2. Release the clips that secure the mirror cover.
  3. Disconnect the harness connectors.
  4. Release the fasteners that secure the mount plate (torque 1 Nm). Allow the camera to hang by its harnesses.
    Informational PurposesAn informational icon, calling your attention
    Note
    Note the harness routing for proper reinstallation.
    Informational PurposesAn informational icon, calling your attention
    Note
    Some vehicles might have a plastic pitch carrier installed. Remove the pitch carrier.
  5. Release the fasteners that secure the glare shield to the windshield (torque 1 Nm). Remove the glare shield from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    When removing the glare shield, do not allow the light/temperature/humidity sensor to fall out of the plastic carrier.

Installation

  1. If there is no foam tape applied to the glare shield, cut pieces of 6 mm x 30 mm double-sided foam tape and apply them to the glare shield.
  2. Clean the inner windshield camera viewing area with a clean microfiber cloth and glass cleaner. Let the windshield fully dry before continuing.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Verify that the windshield has no stains or leftover residue. Otherwise, Autopilot features may be hindered.
  3. Install the glare shield on to the windshield (torque 1 Nm).
  4. Install the mount plate (torque 1 Nm), making sure the harnesses are properly routed.
  5. If the vehicle had a pitch carrier installed, install a new pitch carrier of the same color.
  6. Connect the harnesses and route them as shown. Affix the connectors to the double-sided foam tape on the underside of the glare shield.
    1 Connectors affixed to double-sided foam tape
    2 Red and black wires routed to the LH side of camera
    3 Blue and black wires routed forward of camera LH harness
    3 Camera RH harness routed towards the RH side of vehicle.
  7. Perform a pre-calibration (refer to procedure).
  8. Reinstall the mirror cover.
  9. Reinstall the mirror.