Bumper Beam - Front (Remove and Replace)
Correction code
10011102
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
- 2026-06-24: Released new procedure.
Remove
- Disconnect 12V power. See Disconnect 12V Power.
- Remove the front fascia. See Fascia Assembly - Front (Remove and Install).
-
Remove fastener from positive
ground
Note1x bolt, 10mm , 6Nm
-
Disconnect the front bumper
accelerator sensor electrical connector
Note1x locking tab
-
Release bumper foam
Note4x clips
-
Remove front bumper accelerator
sensor
Note10mm, 1x bolt, 10Nm
-
Remove front bumper beam to the
vehicle
Note4x nuts, 15mm, 60 Nm, 4x bolts, 15mm, 60N
Install
-
Install front bumper beam to the
vehicle
Note4x nuts, 15mm, 60 Nm, 4x bolts, 15mm, 60N
-
Install front bumper accelerator
sensor
Note10mm, 1x bolt, 10Nm
-
Install bumper foam
Note4x clips
-
Connect the front bumper accelerator
sensor electrical connector
Note1x locking tab
-
Install fastener to positive
ground
Note1x bolt, 10mm , 6Nm
- Install the front fascia. See Fascia Assembly - Front (Remove and Install).
- Connect 12V power. See Disconnect 12V Power.