15/07/2022 08:45:59

Bumper Assembly - Front (Remove and Replace)

Correction Code 10011102

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the 12V power supply is disconnected, do not attempt to open any doors with door glass in closed position. Failure to follow this instruction could result in door glass shatter.
Informational PurposesAn informational icon, calling your attention
Note
Before disconnecting the 12V power supply, ensure that the driver’s door window is fully open. Failure to follow this instruction could result in vehicle lockout.

Removal

  1. Disconnect 12V power. See Disconnect 12V Power .
  2. Remove the front fascia assembly for access (refer to procedure).
  3. If installed, remove the plastic rivets (x3) that secure the knee support foam to the front bumper. Remove the knee support foam.
  4. If equipped, remove the bolts (x4) that secure both horn brackets to the bumper carrier and tie the horns aside (torque 11 Nm).
  5. Remove the plastic rivets (x3) that secure the foam to the front bumper. Remove the bumper foam, if installed.
  6. Remove the bolts (x2) that secure the bumper to the carrier (torque 11 Nm).
  7. Disconnect the harness connectors (x2) from the LH fan control module.
  8. Remove the nuts (x2) that secure the LH fan control module to the chassis rail (torque 8 Nm).
  9. Remove the LH fan control module.
  10. Repeat the previous 3 steps to remove the RH fan control module.
  11. Remove the bolts (x8) that secure the bumper to the crash structure (torque 60 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    If necessary, remove the screws (x4) that secure the RH sub-cool condenser mounting clamps (torque 3 Nm) in order to access the lower outboard bolt that secures the RH side of the bumper to the crash structure.
  12. Remove the front bumper.

Installation

  1. Installation procedure is the reverse of removal.