26/07/2023 17:00:20

Duct - Condenser LH (Remove and Replace)

Correction Code 18501002

Removal

  1. Remove the front fascia assembly (refer to procedure).
  2. Remove the bolts (x4) that secure the duct to the condenser housing (torque 16 Nm on vehicles equipped with a magnesium Carrier, torque 4 Nm on vehicles equipped with a composite Carrier).
  3. Remove the duct from the bracket.

Installation

Installation procedure is the reverse of removal, except for the following:
  1. Power cycle the thermal controller:
    1. Remove the Thermal System Controls fuse (F22).
    2. Wait approximately 30 seconds.
    3. Reinstall fuse F22.
  2. After installation, calibrate the Louvre Shutters:
    1. Connect a laptop with Toolbox 3 to the vehicle.
    2. Unlock the vehicle gateway. See Gateway Unlock.
    3. In Toolbox 3, click the Actions tab, type "Louver-Calibration" into the search field, click PROC_THC_X_LOUVER-CALIBRATIONvia Toolbox: (link), click Run, and allow the routine to complete.
    4. Disconnect Toolbox and remove the laptop from the vehicle.