02/03/2020 13:50:14

Backplate - Door - Exterior Handle - Rear - LH (Remove and Replace)

Correction Code 11454202

Removal

  1. Remove the exterior door release handle assembly (refer to procedure).
  2. Fully lower the regulator.
  3. Position the assembly on a soft working surface.
  4. Remove and discard the door handle rear seal from the assembly.
  5. Remove the screws that secure the backplate to the assembly (torque 2 Nm).
  6. Remove the backplate from the assembly.

Installation

Installation procedure is the reverse of removal, except for the following:

Install a new door handle rear seal on the exterior door release handle assembly:

  1. Align the holes in the new door handle rear seal to the studs on the exterior door release handle assembly.
  2. Use a cable tie to secure the seal to the assembly.
    Figure 1. Rear door handle
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To avoid damage to the electrical harness, properly route the wires.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To avoid damage to the seal, do not over-tighten the cable tie.
  3. Use a suitable tool, such as a socket extension, to press the outside edge of the seal firmly against the assembly.
  4. Use a deep 5 mm socket to press the push nuts onto the studs.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not use excessive force to press the push nuts onto the studs.
  5. Verify that each push nut is set onto its stud with no gap between the seal and assembly.