21/12/2021 08:06:00

Sensor - Wheel Speed - ABS - Rear - LH (Remove and Replace)

Correction Code 33100702

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.

Removal

  1. Raise and support the vehicle (refer to procedure)
  2. Remove road wheel for access (refer to procedure)
  3. Remove screw securing wheel speed sensor to knuckle (torque 8 Nm).
  4. Release wheel speed sensor from knuckle.
  5. Release wheel speed sensor harness from securing clip and bracket.
  6. Remove mid aero shield (refer to procedure)
  7. Working from below, disconnect wheel speed sensor connector.
  8. Release clips (x4) securing wheel speed harness.
  9. Remove wheel speed sensor.

Installation

Installation procedure is the reverse of removal, except for the following:
Informational PurposesAn informational icon, calling your attention
Note
Perform a test drive that includes a minimum speed of 25mph in straight line for at least five seconds to allow the ESP internal system checks to complete. The ESP faults will clear if the vehicle is repaired correctly. If faults are persistent after the test drive, continue troubleshooting the repair.