28/03/2023 14:38:58

Actuator - Mode (Remove and Replace)

Correction Code 18102202

  • 2023-03-27: Updated procedure to revised validation.

Removal

  1. Remove the IP carrier. See IP Carrier (Remove and Replace).
  2. Disconnect the LH footwell duct temperature sensor harness connector.
  3. Remove the screw that attaches the LH footwell duct to the HVAC assembly, and then remove the duct from the vehicle.
  4. Disconnect the mode actuator harness connector.
  5. Remove the screws (x3) that attach the mode actuator to the HVAC assembly, and then remove the actuator from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of the actuator position during removal.

Installation

  1. Position the mode actuator on the vehicle, and then install the screws (x3) that attach the actuator to the HVAC assembly.
    1 Nm (.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of the actuator position during installation.
  2. Connect the mode actuator harness connector.
  3. Position the LH footwell duct on the vehicle, and then install the screw that attaches the duct to the HVAC assembly.
    1 Nm (.7 lbs-ft)
  4. Connect the LH footwell duct temperature sensor harness connector.
  5. Install the IP carrier. See IP Carrier (Remove and Replace).
  6. Perform a cooling system thermal test. See Cooling System - Thermal Test.
    Informational PurposesAn informational icon, calling your attention
    Note
    The thermal test will confirm functionality and clear any alerts / DTCs.