04/04/2022 14:07:22
Brake Hose - Flexible - Rear - LH (Remove and Replace)
Correction Code 33030502
Warning
If the vehicle has air
suspension, activate "Jack" mode on the touchscreen before raising and
supporting the vehicle.
Note
Replace the flexible brake hose whenever the caliper is replaced, or the banjo bolt
is loosened.
Removal
- Remove the rear portion of the wheel arch liner and move it away from the working area (refer to procedure).
- Place a suitable container under the vehicle to collect brake fluid.
- Clean the areas that surround the connections at each end of the brake hose.
-
Remove the bolt that attaches the
brake hose to the caliper (torque 42 Nm).
CAUTIONPlug pipe connections to prevent ingress of moisture or dirt.NotePlace suitable absorbent material around the affected area to absorb any possible fluid spillage.CAUTIONIf brake fluid is spilled on a painted surface, wash off immediately with clean water.
-
Loosen the nut that secures the brake pipe to to the brake hose, then disconnect
the brake pipe from the hose (torque 14 Nm).
CAUTIONTo prevent damage always use a suitable wrench to hold the backing nut when loosening pipes and unions.CAUTIONPlug pipe connections to prevent ingress of moisture or dirt.NotePlace suitable absorbent material around the affected area to absorb any possible fluid spillage.
- Note the orientation of the retaining clip that secures the brake hose to the fixed bracket. Remove the retaining clip and release the brake hose from the bracket.
-
Note the orientation of the brake hose. Remove the brake hose from the
vehicle.
CAUTIONPlug pipe connections to prevent ingress of moisture or dirt.
Installation
Note
Clean the affected areas before
installation.
CAUTION
Ensure that the brake hose is oriented
correctly with no excessive twist or bends.
CAUTION
Ensure that the retaining clip that
secures the brake hose to the fixed bracket is oriented correctly.
- Bleed the brake caliper (refer to procedure).