02/03/2020 13:50:14

Air Line - Air Suspension - Reservoir to Compressor (Remove and Replace)

Correction Code 31104302

Removal

  1. Raise and support the vehicle (refer to procedure).
  2. Depressure the air suspension system (refer to procedure).
  3. Disconnect 12V power. See Disconnect 12V Power .
  4. Remove the underhood storage unit (refer to procedure).
  5. Release the fitting from the compressor (torque 3.5 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug the line connection to prevent ingress of moisture or dirt.
  6. Release the air line clips (x3) between the compressor and the reservoir.
  7. Use 2 wrenches to release the fitting from the reservoir: 1 to hold the fitting (12 mm) and 1 to hold the mounting (13 mm) (torque 5 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug the line connection to prevent ingress of moisture or dirt.

Installation

Installation procedure is the reverse of removal, except for the following:
Perform the following steps to resecure air suspension lines:
  1. Remove the collet and fitting from the air suspension line. Discard the collet and fitting.
    1Collet
  2. Secure a new VOSS fitting onto the component. Remove any plastic plugs from the new fitting.
  3. Insert the air suspension line as far as possible into the fitting.
  4. Gently pull on the air suspension line to make sure the line is fully secured to the compressor.