10/12/2023 18:57:47

Door Glass - LH - Front - Adjust

Correction Code 11010004 Adjustable FRT NOTE: This procedure uses an adjustable correction code. Use the correction code listed above and manually enter the actual amount of time spent performing this procedure. Do not stack correction codes unless explicitly told to do so. NOTE: See to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See to make sure wearing proper PPE when performing the below procedure.

  • 2023-12-11: Updated the original nonadjustable correction code to the new adjustable one.

Removal

  1. Remove door trim pad (refer to procedure)
  2. Loosen but do not remove clamp nut securing door glass to regulator (torque 7.5 Nm). This allows glass to move fore and aft.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  3. Remove plugs (x2) from bottom of door covering regulator adjustment nuts
  4. Loosen nuts (x2) securing regulator adjustment, inboard and outboard to seal (torque 10 Nm).
  5. Align door glass to create best fit condition, torque tighten glass clamp and regulator lower adjusters.

Installation

  1. Installation procedure is the reverse of removal, except for the following:
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Always replace plugs or tape removed from the front door shells when servicing or inspecting the door or its components. Additional holes in the door creates more escape paths for air, which decreases the front door pressure sensor's ability detect a side impact, and can negatively affect airbag deployment.
  2. Cover openings with waterproof adhesive tape.
  3. Check glass for smoothness of operation and seating to body opening seals, re-adjust if necessary.