13/04/2022 00:16:07

Brake Pad Kit - Rear - Brembo (Remove and Replace)

Correction Code 33010802

Warning

If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.

Special tools recommended for this procedure:

Note

For detailed brake specifications, see Brakes.

Removal

Remove the rear underhood apron (refer to procedure).
Remove the brake fluid reservoir cap.

CAUTION
Clean the surrounding area prior to removing the component.

Note
Place suitable absorbent material around the affected area to absorb any possible fluid spillage.
Remove the rear wheels (refer to procedure).
Remove the pad retaining pins and collect the anti-rattle spring.

Note
Always check that the anti-rattle clip has not been damaged. This part is easily damaged and is important to help eliminate squeaks.
Use the caliper spreader tool or similar tool to gently push the pistons back into the caliper.
Remove the brake pads from the caliper.
Check that the caliper pad slides are dirt free and the seals are in good condition.

Installation procedure is the reverse of removal, except for the following:

Note

Clean the affected areas before installation.

Thoroughly clean the caliper pad slides and abutments with the disc brake caliper brush (tool part number 1115240-00-A) and soapy water.
CAUTION
If there is rust or pitting on the caliper that cannot be removed with a hand brush, replace the caliper (refer to procedure).
Apply an even layer of Silaramic lubricant (1063021-00-A) to the caliper pad slides. Remove any excess lubricant.
Pump the brake pedal at least 5 times to seat the pads against the brake rotors.
Warning
Always check that the brake pads are seated correctly before driving the vehicle.
Top off the brake fluid level as required.
CAUTION
If brake fluid is spilled on a painted surface, wash off immediately with clean water.
Burnish the brake pads. See Brake Pads - Burnishing.