18/03/2022 06:57:31

Raise Vehicle - 2 Post Lift

Correction Code 10000205

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
"Jack mode" must be activated on vehicles with air suspension before lifting the vehicle. Failure to do this might lead to suspension damage and could cause serious personal injury.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Failure to follow the critical steps and checks of this procedure can lead to serious injury or death.
Informational PurposesAn informational icon, calling your attention
Note
Vehicles with air suspension might need the suspension to be set to "High" or "Very High" to allow the vehicle to be positioned and supported correctly on a vehicle lift.

Raise

  1. Position the vehicle centrally between the lift posts.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    To avoid personal injury, use appropriate equipment when performing this operation.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Do not work on an incorrectly supported vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Perform a visual check of the lift according to the equipment operator's manual before using the lift.
  2. Activate "Jack mode" if the vehicle has air suspension (refer to procedure).
  3. Position the front and rear lifting arm pads under the vehicle lift points shown.
  4. Adjust the lifting arm pads to the optimum height.
  5. Before raising the vehicle, check that the arms are correctly located and that no part of the vehicle is in danger of contacting the ceiling, tool boxes, or other items in the service area.
  6. Raise the vehicle slightly, and check the following:
    • Make sure all 4 pads are in the correct position.
    • Check the balance of the vehicle.
    • Make sure that the four arms are properly locked and cannot rotate.
  7. Raise the vehicle to the necessary service height, and then lower the lift until the safety locks are properly engaged.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If the procedure requires the liftgate to be open while the vehicle is raised, closely watch the position of the liftgate as the vehicle is being raised to avoid contact with the lift mechanism, ceiling, or objects hanging from the ceiling.

Lower

  1. Make sure that no tools, equipment, other items, or personnel are under the vehicle or under any open doors.
  2. Disengage any lift safety locks, and fully lower the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To avoid injuries, stay clear from the vehicle.
  3. Move the lifting arms fully out from under the vehicle, and lower the lifting pads.
  4. Close any open hood, liftgate, or doors as necessary.
  5. Remove the vehicle from the lift.