2026-09-11

Bracket - Rear Wing - LH (Remove and Replace)

Correction code 10016102 FRT 1.08 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install).
  2. Remove the screws (x5) that attach the LH rear wing bracket to the vehicle.
    Tip
    Use of the following tool(s) is recommended:
    • 4 in extension
    • Ratchet/torque wrench
    • T30 bit
  3. Release the clips (x5) and remove the LH rear wing bracket from the vehicle.

Install

  1. Position the LH rear wing bracket onto the vehicle, and then install the clips.
  2. Install the screws (x5) that attach the LH rear wing bracket to the vehicle.
    4 Nm (2.9 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 4 in extension
    • Ratchet/torque wrench
    • T30 bit
  3. Install the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install).