29/04/2022 09:34:27

Sensor - Parking Distance - Inner - Rear (Remove and Replace)

Correction Code 17271112

Informational PurposesAn informational icon, calling your attention
Note
This procedure applies to rear parking sensors 8, 9, 10, and 11.

Removal

  1. Remove the rear fascia assembly (refer to procedure).
  2. Set the fascia assembly on a flat, clean surface.
  3. Release the locking tab, and then disconnect the electrical harness from the parking distance sensor.
  4. Carefully release the tabs that attach the parking sensor to the fascia bracket, and then remove the sensor from the bracket.
    Tip: If needed, use a pick or small flat head screwdriver to carefully release the bracket tabs.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the sensor retainer ring is also removed.
  5. If reusing the retainer ring, remove the retainer ring and inspect for damage.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not reuse the ring if it is overly worn or damaged.

Installation

  1. Installation procedure is the reverse of removal, except for the following:
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure a retainer ring is installed on the new parking sensor.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure the fascia sensor bracket tabs are securely holding the sensor. If necessary, carefully bend the tabs inward so that the sensor is securely held in place.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a push-pull-push test on the electrical harness to verify proper connection.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the sensor retainer ring is fully seated against the fascia.