2026-08-04

Fairing - Rocker Panel - Rear - LH (Remove and Replace)

Correction code 12202202 12202302 12202201 12202301 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-08-03: Released new procedure.

Remove

  1. If equipped, set the air suspension ride height to “Very High” and enter Jack Mode.
  2. Remove the clips (x4) that secure wheel arch liner.
  3. Remove the clips (x2) that secure the fairing to the shear plate.
  4. Remove the bolt that secures the fairing to the body from underneath the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
    1.5 Nm (1.1 lbs-ft)
  5. Remove the bolt that secures the fairing to the body behind the rear wheel arch liner.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  6. Slide back and pull the fairing down to remove it from the vehicle.

Install

Installation procedure is the reverse of removal, except for the following: