14/12/2022 00:55:17

Applique - Fascia - Front - 1st Generation (Remove and Replace)

Correction Code 10011402

Informational PurposesAn informational icon, calling your attention
Note
This procedure describes how to remove and replace the 1st generation front fascia applique. If the vehicle is equipped with a 2nd generation front fascia applique, refer to procedure 10011302 (refer to procedure).

Removal

  1. Remove the front fascia grill (refer to procedure).
  2. If installed, remove the clips (x3) that secure the license plate mounting panel to the applique. Remove the license plate mounting panel.
  3. If installed, disconnect the park assist sensor connectors (x2).
  4. Release the harness clips (x7) that secure the fascia harness to the applique.
  5. Carefully release the park assist sensors (x2) from the applique retaining rings.
  6. Carefully release and remove the sensor retaining rings (x2) from the applique.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Care must be taken to avoid damage to paintwork and exterior trim.
  7. Remove the screws (x4) that secure the applique to the fascia (torque 1 Nm).
  8. Release the clips (x6) that secure the applique to the fascia.

Installation

Installation procedure is the reverse of removal.