2020-03-02

Seatback Assembly - 2nd Row - Executive (Remove and Replace)

Correction Code 13054402

Removal

  1. Remove the LH and RH lower seat cushions (refer to procedure).
  2. On each side of the vehicle, remove the screw that secures the closeout panel to the seat frame (torque 5 Nm). Remove the panel from the vehicle.
  3. Carefully remove the NVH pad from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure that the black portion of the pad faces up during reinstallation.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not tear the NVH pad.
  4. Disconnect the harness and release the edge clip.
  5. On each side of the vehicle, release the bolt that secures the seatback to the body (torque 26 Nm).
  6. Release the seatback:
    • Vehicles built before April, 2015:
      On each side of the vehicle, release the latches that secure the seatback. Pull the seatback towards the front of the vehicle.
      Informational PurposesAn informational icon, calling your attention
      Note
      These latches are inside the seatback and are not visible. Position your hand as shown.
    • Vehicles built during and after April, 2015:

      On both sides of the vehicle, reach between the seat back carpet and C-Pillar trim panel to expose the strap. Pull the strap straight down to release the seat.

      Figure 1. Strap highlighted in yellow
      Warning IconA warning icon, calling your attention to a possibly risky situation
      CAUTION
      Only pull the strap from the trunk.
      Informational PurposesAn informational icon, calling your attention
      TIp
      If the strap is not easily accessible, move to the 2nd row of the vehicle. Gently push the outboard edge of the seat inboard to expose the strap, then feed the strap between the seat and C-Pillar so that it can be accessed from the trunk.
      Figure 2. Strap highlighted in yellow
    Informational PurposesAn informational icon, calling your attention
    Note
    Before proceeding, have an assistant stand outside the vehicle.
  7. Carefully pass the seatback through one of the rear door openings to an assistant.

Installation

Installation procedure is the reverse of removal.