2026-04-03

Filter - HEPA (Remove and Replace)

Correction Code 18105502

Removal

  1. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Install).
    Figure 1. Animated demonstration
  2. Release the bolts (x10) that secure the HEPA filter to the underhood storage unit.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Carefully remove the HEPA filter from the underhood storage unit.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Set the filter with the plastic trim side facing down. Do not damage the filter.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift up from bottom and then pull out.

Installation

Installation procedure is the reverse of removal.