30/05/2024 07:16:04

Hood Assembly (Remove and Install)

Correction Code 10100301

Removal

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .
  2. Remove the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace) .
  3. Mark the installed position of the hood hinges to the body.
  4. Remove the clips (x9) that attach the hood harness to the hood assembly.
  5. Disconnect the LH and RH hood washer jet electrical connectors.
  6. Disconnect the y-tubes from the LH and RH washer jet hoses.
  7. With assistance, support the weight of the hood.
  8. Release the clips (x2) and disconnect the gas struts (x2) from the hood mounting bracket ball joints.
  9. Remove the bolts (x4) that secure the LH and RH hood hinges to the body (torque 24 Nm).
  10. With assistance, remove the hood.

Installation

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
If using this procedure to install an unpainted part, make sure to apply seam sealer to all seams prior to installing and painting the part. Refer to the Collision Repair manual for more information.

Installation procedure is the reverse of removal, except for the following:

Informational PurposesAn informational icon, calling your attention
Note
Clean the affected areas before installation.
  1. Align the hood hinges to their previously marked locations.
  2. Check the alignment of the hood to the body and adjust as necessary.