02/03/2020 13:50:14
Applique - Liftgate (Remove and Replace)
Correction Code 12207002
Special tool required for this procedure:
Supplier | Part Number | Description |
Tesla | 1049517-00-A | Ergonomic Silicone Seam Roller |
Bosch | 732-PHT318-TSL | Molding Hold Down Tool |
Removal
CAUTION
Protect exterior paint surfaces that surround the liftgate applique
before performing this procedure.
-
Using a trim stick or other suitable tool, carefully and evenly release the
fasteners (x5) that secure the applique to the liftgate body panel.
CAUTIONCare must be taken to avoid damage to exterior trim mounting points.
- Carefully release the adhesive tape that attaches the applique to the fog/reverse lights.
- Remove the rear applique.
-
Inspect the clips for damage, and replace if required.
Installation
Installation procedure is the reverse of removal, except for the following:
-
If there is an adhesive patch
located in the liftgate area, replace it with a rubber plug.
- Remove all remaining adhesive from the applique and the tail/backup lights.
-
Clean the mating surfaces and
lenses on the applique and the tail/backup lights with an isopropyl alcohol-based
solution. Allow the alcohol to fully dry before moving forward with the
procedure.
CAUTIONIn order to prevent cracking the lens, only use isopropyl alcohol to clean the lens.
- Apply new applique tape when reinstalling the applique.
-
Working outwards from the center of the applique, press very firmly on the
applique using a silicone seam roller to completely seal the applique tape.
CAUTIONDo not damage the liftgate applique lenses.
Top path highlighted Bottom path highlighted -
Apply pressure to both ends of the applique: