25/03/2024 17:23:59

Module - HomeLink Transmitter (Remove and Replace)

Correction Code 17154202

Removal

  1. Remove the front fascia. See Fascia Assembly - Front (Remove and Install).
  2. Disconnect the HomeLink transmitter module from the wiring harness.
  3. Release the clips (x2) that secure the HomeLink transmitter module to the bracket.
  4. Remove the HomeLink transmitter module.

Installation

Installation procedure is the reverse of removal, except for the following:
  1. Make sure that the Gateway configuration is corretly set. See Gateway Configuration (Display and Change) and set the value for homelink as shown below:
    • When installing a homelink module with part number 1020147 or 1005371, set the value to gen1
    • When installing a homelink module with part number 1114984, set the value to vopt2
  2. Encode the module with the appropriate country code:
    1. In Toolbox 3, select the Actions tab, and then search for "Homelink Country".
    2. Select the ODIN routine PROC_MCU_X_SET-HOMELINK-COUNTRYvia Toolbox: (link), and then click on the link of the routine.
    3. Click RUN, and allow the routine to complete.
    Informational PurposesAn informational icon, calling your attention
    Note
    The region to program is automatically detected by the routine from the vehicle configuration data.
  3. After encoding the module, park the vehicle near the relevant door or gate and program the HomeLink module. Refer to the Owner's Manual for instructions.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the HomeLink module is replaced at a Service Center, instruct the customer to refer to the Owner's Manual for Homelink programming instructions.