10/12/2024 14:46:04

Fixed Glass Roof Rack (Retrofit)

Correction Code 24300006

  • 2024-12-10: Added new caution about Pre-Installation Glass Inspection service requirements.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
New glass components (windshield, roof, door, and fixed glass) must be inspected before installation to meet Tesla’s internal standards of quality. Perform the inspection described in Pre-Installation Glass Inspection before beginning this procedure.

This procedure describes the removal of a first generation fixed glass roof and subsequent retrofit of a 2nd generation fixed glass roof that supports the installation of a roof rack.

Special tools required for this procedure:
Informational PurposesAn informational icon, calling your attention
Note
These part numbers were current at the time of publication. Use the revisions listed or later, unless otherwise specified in the Parts Catalog.
SupplierPart NumberDescription
Tesla1080599-00-ASSC209 Vacuum Cups (2 sets)
Tesla1064740-00-AAdhesive Scraper Tool
Tesla1080619-00-AJN1130-Wire Starter
Tesla1078736-00-ASWL165 Squire Wire (164ft roll)
Tesla1078806-00-ALWH200 Griptite
Parts required for this procedure:
Informational PurposesAn informational icon, calling your attention
Note
These part numbers were current at the time of publication. Use the revisions listed or later, unless otherwise specified in the Parts Catalog.
Part NumberDescriptionQty
1490009-00-A ASY FIXED GLASS ROOF RACK MOUNT BLOCK4
1052779-00-AGASKET, ROOF RACK BRKT8
1116867-00-ANUT,HF,M6-1.0,[8],ZNNI[B]8
1018062-00-ACAP,HEX,M6[Plastic]-DOME8
1490219-00-BMODEL S, FIXED GLASS ROOF, NARROW1

Procedure

  1. Remove and discard the fixed roof glass per local regulations. See Roof - Glass (Remove and Replace) .
  2. Install 1 gasket on each fixed glass roof rack mount block stud (x8).
  3. Position the fixed glass roof rack mount blocks on the vehicle, and then tighten the nuts (x8) that attach the mount blocks to the vehicle (torque 11 Nm).
  4. Install 1 plastic dome hex cap over each fixed glass roof rack mount block stud (x8).
  5. Install the new fixed roof glass. See Roof - Glass (Remove and Replace) .