02/03/2020 13:50:14

Crossmember - Front Trunk (Remove and Replace)

Correction Code 15246002

Removal

  1. Remove the front fascia (refer to procedure).
  2. Release the fasteners that secure the duct to the carrier (torque 7 Nm).
  3. Disconnect the harness connector from the radar sensor. Remove the harness from the bracket.
  4. Release the fasteners that secure the radar bracket to the crossmember, then remove the bracket from the vehicle (torque 4 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Some fasteners might have washers. Install the washers into the same locations during reinstallation.
  5. Disconnect the harness connector from the LH side of the hood latch.
  6. Remove the bolts that secure the hood latch to the crossmember (torque 10 Nm).
  7. Remove the bolts that secure the hood latch release to the crossmember (torque 10 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Components have been removed in this graphic to aid clarity.
  8. Release the fasteners that secure the front trunk safety release switch. Remove the switch and pull the harness through the crossmember (torque 1.5 Nm).
  9. Remove the lower fasteners that attach the crossmember to the headlight bracket (torque 9 Nm).
  10. Remove the upper fasteners that attach the crossmember to the headlight brackets (torque 7 Nm).
  11. Remove the crossmember from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

Perform a front radar calibration (refer to procedure).