2025-07-03

Fascia Assembly - Rear - Partially Remove (Mobile Only) ((拆卸和安装))

校正代码 10010501701 0.30 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。 注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至ServiceManualFeedback@tesla.com。 注意：请参阅人员保护，确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。

2025-06-11: Released new procedure.

拆卸

Release the rear half of the LH and RH rear fender garnish from the vehicle.

注
6x clips, 2x tabs. Release from center of garnish and work your way outward towards the rear. Use a clip prytool to release the clips at the rear of the fascia to avoid damage to the garnish.
Open the liftgate.
Apply masking tape around the LH corner of the rear upper fascia.
Partially release the LH rear trough trim.

注
3x clips
Remove the bolt that attaches the LH corner of the rear fascia to the body.
Remove the screw that attaches the LH rear fascia to the body.
Repeat steps 3 through 6 at the RH side of the vehicle.
Release rear fascia diffuser

注
2x fastener covers, 7x bolts, 6x push clips.
Release the rear fascia assembly from the body and tilt it down onto a foam pad.

注
1x connector. Place the rear fascia on a padded surface to avoid damage.