2026-04-30
3rd row - Outer B-cover - LH (7-Seat)(Remove and Replace)
校正代码
1309010701
1309010702
注意：除非本程序中另有明确规定，否则上文所列校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。
注意：请参阅平均维修工时深入了解 FRT 及其创建方式。
注意：请参阅人员保护确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。
注意：请参阅人体工程学注意事项查看安全健康的作业规程。
警告
本程序为“草案”。虽已通过验证，但可能仍有“警告”和“注意”事项缺失。请遵守安全要求，处理或靠近高压系统和部件时，请谨慎操作。
- 2026-01-26: Released new procedure.
-
Open all four doors
-
Lower all four windows
-
Open liftgate
-
Remove trunk load floor from vehicle
-
Move LH front seat forward
-
Position 60 seat into easy entry mode
注Press shoulder switch and push 60 seat forward to position into easy entry mode
-
Move RH front seat forward
-
Position 40 seat into easy entry mode
注Press shoulder switch and push 40 seat forward to position into easy entry mode
-
Remove 3rd row seat cushion and disconnect harness
注1x connector, Pull LH and RH release lever under 3rd row seat cushion to release seat cushion
-
Remove 3rd row LH seat cushion bolster
注1x bolt, 11mm, 37 Nm, 1x location pin, 1x tab, Slide LH seat cushion bolster towards front of vehicle to remove
-
Remove LH outer cover
注1x clip, 1x tablift/pry front then rear to release cover, slightly recline seat forward for easy removal of rear clip, then push from rear to remove from inner cover.
-
Install LH outer cover
注1x clip, 1x TabInsert outer cover into position and engage rear clip, re-engage front tab of outer cover
-
Install 3rd row LH seat cushion bolster
注1x bolt, 11mm, 37 Nm, 1x location pin, 1x tab, Slide LH seat cushion bolster into seat frame complete
-
Install 3rd row seat cushion and connect harness
注1x connector, Secure 3rd row seat cushion into RH and LH latches
-
Move 60 seat to original position
-
Move LH front seat to original position
-
Move 40 seat to original position
-
Install trunk load floor onto vehicle
-
Move RH front seat to original position
-
Close liftgate
-
Raise all four windows
注Via LH front door switch
-
Close all four doors
注Unlatch doors before closing if necessary