2026-05-28
Power Strut - Liftgate - LH (Model Y Standard) (Remove and Replace)
校正代码
11332902602
FRT
0.24
注意：除非本程序中另有明确规定，否则上文所列校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。
注意：请参阅平均维修工时深入了解 FRT 及其创建方式。
注意：请参阅人员保护确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。
注意：请参阅人体工程学注意事项查看安全健康的作业规程。
- 2026-05-07: Released new procedure.
拆卸
-
Open the liftgate and support it with a telescoping hood prop.
-
Fold 2nd row LH seatback down
注Protect seat back upholstery if necessary
- Remove the LH rear body primary seal. See 密封条 - 主 - 车身 - 后 - 左侧 ((拆卸和更换)).
-
Partially remove the LH trunk side trim. See 后备箱左侧饰板 - 后车底 ((拆卸和更换)).
注Release only the upper section of trim, Use caution to avoid straining 12v socket harness at rear of trim, All clips and datums shown in image for clarity
- Remove the LH upper C-pillar trim. See 饰板 - 上 - C 柱 - 左侧 ((拆卸和更换)).
-
Release the rear LH section of the headliner.
注3x clips, 1x guide pin, Pull down as required to provide access to power strut connector.
-
Disconnect the power strut connector from the body harness.
-
Release the LH rear power strut harness grommet from the body.
-
Release the LH upper power strut clip from the liftgate side ball stud, and lay the power strut down on the door jamb.
-
Release the power strut clip from the body side ball stud.
安装
-
Install the power strut clip to the body side ball stud.
注Ensure that the spring clip is reset.
-
Install the power strut clip to the liftgate side ball stud.
注Ensure that the spring clip is reset.
- Remove the telescoping hood prop from the vehicle.
-
Insert the power strut harness into the body and install the grommet.
-
Connect the power strut harness connector.
-
Install the rear LH section of the headliner.
- Install the LH upper C-pillar trim. See 饰板 - 上 - C 柱 - 左侧 ((拆卸和更换)).
- Secure the LH trunk side trim. See 后备箱左侧饰板 - 后车底 ((拆卸和更换)).
- Install the LH rear body primary seal. See 密封条 - 主 - 车身 - 后 - 左侧 ((拆卸和更换)).