Release Cable - Charge Port (NA) (Remove and Replace)
Correction code
44013202
0.45
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 모든 도어를 열고 창문을 내립니다.
- 후드, 트렁크 및 충전 포트 도어를 엽니다.
- 2열 시트 쿠션을 탈거합니다. Seat Cushion - Lower - 2nd Row (Remove and Replace)을(를) 참조하십시오.
- 12V/LV 전원을 연결 해제합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
- 충전 포트 전압 점검을 수행합니다. Charge Port Voltage Check을(를) 참조하십시오.
- LH 트렁크 사이드 트림을 탈거합니다. Trim - Side - Trunk - LH (Remove and Replace)을(를) 참조하십시오.
- 충전 포트 안전 캡을 탈거합니다. Safety Cap - Busbar - Charge Port to HV Battery (Remove and Replace)을(를) 참조하십시오.
-
고정 클립에서 수동 해제 케이블을 밀어서 빼냅니다.
-
캐리어 어셈블리에서 충전 포트 수동 해제 케이블 클립을 분리합니다.
-
수동 해제 케이블을 충전 포트에 고정하는 에지 클립을 들어 올립니다.
-
로커 암 위치를 기록한 다음 래치 액추에이터 어셈블리를 로커 암에서 조심스럽게 분리합니다.
- 차량에서 수동 해제 케이블을 탈거합니다.
Install
Installation procedure is the reverse of removal.