Striker - Trunk (Remove and Replace)
Correction code
11353402
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 후면 트렁크 씰 트림을 탈거합니다. Trim - Sill - Trunk (Remove and Replace)을(를) 참조하십시오.
- 마스킹 테이프를 사용하여 트렁크 스트라이커의 위치를 표시합니다.
-
트렁크 스트라이커를 차체에 고정하는 볼트를 탈거한 다음 차량에서 스트라이커를 탈거합니다.
Install
- 트렁크 스트라이커를 차체의 마스킹 테이프에 맞춰 정렬한 다음, 트렁크 스트라이커를 차체에 고정하는 볼트를 손으로 조입니다.
- 트렁크를 닫고 간격/단차를 점검합니다.
- 트렁크를 열고 필요에 따라 스트라이커 위치를 조정합니다.
- 적절히 정렬될 때까지 2 단계와 3 단계를 반복합니다.
-
트렁크 스트라이커를 차량에 고정하는 볼트를 완전히 조입니다.24 Nm (17.7 lbs-ft)
- 마스킹 테이프를 제거하고 후면 트렁크 씰 트림을 장착합니다. Trim - Sill - Trunk (Remove and Replace)을(를) 참조하십시오.