Mount - Front Drive Unit - LH (Remove and Replace)
Correction code
39012600
3.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
- 2025-06-17: 마운트 볼트를 "재사용"에서 "교체"로 업데이트하고 볼트 부품 번호를 추가했습니다.
- 2024-07-03: 얼라인먼트 요구 사항 표를 참조하여 얼라인먼트 점검/조정을 수행하도록 마지막 단계를 변경했습니다.
- 2023-07-26: 깨진 링크를 수정하고 도구 정보를 추가했습니다.
Remove
- 전면 서브프레임 어셈블리를 탈거합니다. 참조 항목: Subframe Assembly - Front (Dual Motor) (Remove and Install).
-
전면 서브프레임 전기 하네스를 전륜 구동 장치 인버터에 고정하는 클립을 분리합니다.
-
LH 전륜 구동 장치 마운트를 전륜 구동 장치에 고정하는 볼트를 탈거하여 폐기한 다음 전륜 구동 장치에서 마운트를 탈거합니다.35 Nm (25.8 lbs-ft) + 55 degreesTIpUse of the following tool(s) is recommended:
- 래칫/토크 렌치
- 외부 Torx E14
Install
-
LH 전륜 구동 장치 마운트를 전륜 구동 장치에 장착한 다음 마운트를 전륜 구동 장치에 고정하는 새 볼트를 장착합니다.35 Nm (25.8 lbs-ft) + 55 degrees참고볼트 PN: 1111864-00-BTIpUse of the following tool(s) is recommended:
- 각도 측정 토크 렌치
- 외부 Torx E14
-
전륜 구동 장치 하네스를 전륜 구동 장치 인버터에 고정하는 클립을 조입니다.
- 전면 서브프레임 어셈블리를 장착합니다. 참조 항목: Subframe Assembly - Front (Dual Motor) (Remove and Install).
- Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust correction code as a separate activity to the SV. See 얼라인먼트 요구 사항 - 서스펜션.