2023-01-25

Airbag - Knee - Driver (Remove and Replace)

Correction code 20010202 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Disconnect the 12V/LV battery and the First Responder Loop. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see 에어백 및 안전보조장치(SRS) 사전 주의 사항.
Informational PurposesAn informational icon, calling your attention
참고
운전석 무릎 에어백은 북미 차량에만 장착되어 있습니다.

Remove

  1. 운전석 무릎 에어백을 탈거합니다. Airbag - Knee - Driver (Remove and Install)을(를) 참조하십시오.
  2. 일자 드라이버를 사용하여 에어백 어셈블리의 후면 가장자리를 따라 압력을 가하는 동안 무릎 에어백 커버 주변을 구부려 커버 주변에서 각 에어백 탭 5개를 분리합니다.
  3. 에어백을 위쪽으로 돌려 커버 주변에서 에어백 전면의 탭 6개를 잠금 해제한 다음 커버에서 에어백을 탈거합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    에어백을 올바르게 폐기합니다.

Install

Installation procedure is the reverse of removal.