2020-12-16

Chime - Power Trunk (Remove and Replace)

Correction code 21214302 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications: Chime - Power Trunk (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
경고벨을 전동식 트렁크 리드 트림에 고정하는 나사
2.3 Nm (1.7 lbs-ft)
  • Torx T20 소켓
  • 4인치 익스텐션
  • 래칫/토크 렌치
Reuse

Remove

  1. 전동식 트렁크 리드 트림을 탈거하고 트림을 깨끗한 작업 면에 배치합니다. Trim - Lid - Power Trunk (Remove and Replace)을(를) 참조하십시오.
  2. 전동식 트렁크 차임벨에서 전기 하네스를 연결 해제합니다.
  3. 전동식 트렁크 차임벨을 전동식 트렁크 리드 트림에 고정하는 나사를 탈거한 다음 트림에서 차임벨을 탈거합니다.
    2.3 Nm (1.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 소켓
    • 4인치 익스텐션
    • 래칫/토크 렌치

Install

Installation procedure is the reverse of removal, except for the following:

새 차임벨의 뒷면 테이프에서 보호용 커버를 제거합니다.