2024-04-08

Sensor - Parking Distance - Inner - Rear (Remove and Replace)

Correction code 17271112 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Informational PurposesAn informational icon, calling your attention
참고
내측 주차 거리 센서는 S8, S9, S10 및 S11입니다. 외측 주차 거리 센서는 S7 및 S12입니다. Sensor - Parking Distance - Outer - Rear (Remove and Replace)을(를) 참조하십시오.

Remove

  1. 후면 페시아를 탈거합니다. 참조 항목: Fascia - Rear (Remove and Install).
  2. 후면 주차 거리 센서 커넥터에서 전기 하네스를 연결 해제합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling the main body of the connector to fully disconnect it.
  3. 후면 주차 거리 센서를 후면 페시아에 고정하는 클립을 분리한 다음 후면 페시아에서 센서를 탈거합니다.

Install

Installation procedure is the reverse of removal, except for the following:

Push the red locking tab towards the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.

부품 카탈로그를 참조하여 차량에 장착된 주차 센서 유형을 확인합니다. 차량에 Tesla USS가 장착된 경우 다음 Toolbox 3.0 루틴을 나열된 순서대로 실행합니다.

  1. TEST-RESET_PARKvia Toolbox: (link)
  2. PROC_USM_REAR_PROGRAM-USS-ADDRESSESvia Toolbox: (link)via Service Mode: Driver Assist ➜ Sensors ➜ Program Rear USS