2025-12-12

Rear Carpet - Trunk (2-Piece) (Remove and Replace)

교정 코드 15302702 15302701 FRT 0.06 바고: 절차에서 명시적으로 언급하지 않는 한 위 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간을 참조하십시오. FRT 값에 대한 피드백을 제공하려면 ServiceManualFeedback@tesla.com으로 이메일을 보내십시오. 참고: 아래 절차를 수행할 때 개인 보호의 내용을 참조하여 적절한 PPE를 착용했는지 확인하십시오. 참고: 안전하고 건강한 작업 사례는 인체공학적 주의 사항의 내용을 참조하십시오.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
이 절차는 초안입니다. 따라서 검증은 되었지만 경고 및 주의 사항이 누락되었을 수 있습니다. 고전압 시스템 및 구성 요소에서 또는 그 근처에서 작업하는 경우에는 안전 요구 사항을 준수하고 최고 수준의 주의를 기울여야 합니다.
  • 2025-12-01: Released new procedure.
  1. Open liftgate from exterior switch
  2. Remove load floor
    Informational PurposesAn informational icon, calling your attention
    참고
    Use pull tab located at rear edge of panel
  3. Remove trunk sill trim assembly
    Informational PurposesAn informational icon, calling your attention
    참고
    4x clips, 1x location pin, Pull corner upward release clip on the end the away from body for remaining clips
  4. Remove clips securing rear trunk carpet
    Informational PurposesAn informational icon, calling your attention
    참고
    2x push clips
  5. Remove rear trunk carpet from vehicle
    Informational PurposesAn informational icon, calling your attention
    참고
    4x velcro strips
  6. Install rear trunk carpet into vehicle
    Informational PurposesAn informational icon, calling your attention
    참고
    4x velcro strips, Fully seat carpet at velcro strips
  7. Install clips securing trunk carpet
    Informational PurposesAn informational icon, calling your attention
    참고
    2x push clips
  8. Install trunk sill trim assembly
    Informational PurposesAn informational icon, calling your attention
    참고
    4x clips, 1x location pin, Align the latch with center slot then 2 locator to their slot and then press to secure the clips, Adjust the seal to overlap the trim
  9. Install load floor
  10. Close trunk