2023-12-26

Clevis Pin - Brake (Remove and Replace)

Correction code 33253102 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 1108272-00-B 캡, 로직 연결, 인버터, 3DU

Remove

  1. 모든 도어를 열고 모든 창문을 내립니다.
  2. 2열 하단 시트 쿠션을 탈거합니다. 참조 항목: Seat Cushion - Lower - 2nd Row (Remove and Replace).
  3. LH 전면 시트를 뒤쪽으로 이동합니다.
  4. 12V 전원을 연결 해제합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
  5. 보조 베이에서 12V 캡을 탈거합니다.
  6. HVC 로직 커넥터를 연결 해제하고 로직 캡을 장착합니다.
  7. 브레이크등 스위치를 탈거합니다. 참조 항목: Switch - Brake Light (Remove and Replace).
  8. 브레이크 클레비스 핀 코터 핀을 탈거합니다.
  9. 브레이크 페달 어셈블리에서 클레비스 핀을 탈거합니다.

Install

  1. 브레이크 페달을 iBooster 로드와 정렬하고 클레비스 핀을 브레이크 페달 어셈블리에 장착합니다.
  2. 브레이크 클레비스 핀 코터 핀을 장착합니다.
  3. 브레이크등 스위치를 장착합니다. 참조 항목: Switch - Brake Light (Remove and Replace).
  4. 로직 캡을 탈거하고 HVC 로직 커넥터를 연결합니다.
  5. 12V 캡을 보조 베이에 장착합니다.
  6. 12V 전원을 연결합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
  7. 2열 하단 시트 쿠션을 장착합니다. 참조 항목: Seat Cushion - Lower - 2nd Row (Remove and Replace).
  8. 모든 창문을 올리고 모든 도어를 닫습니다.