Clean the Blower Motor
Correction code
18103205
0.30
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 후드 내 보관 유닛을 탈거합니다. Underhood Storage Unit (Remove and Replace)을(를) 참조하십시오.
- 외기 흡기 어셈블리를 탈거합니다. Duct - Fresh Intake (Remove and Replace)을(를) 참조하십시오.
- HVAC를 켠 다음 꺼서 외기 인입 덕트를 열고 블로워에 접근합니다.
- 외기 인입 씰에서 떨어진 잔해를 제거합니다.
-
에어 건을 사용해 정비소 공기를 HVAC 모듈 어셈블리에 불어 넣어 블로워에서 먼지 입자를 제거합니다.
- 실내 필터를 탈거합니다. Filter - Cabin (Remove and Replace)을(를) 참조하십시오.
Install
- 실내 필터를 장착합니다. Filter - Cabin (Remove and Replace)을(를) 참조하십시오.
- 외기 흡기 어셈블리를 장착합니다. Duct - Fresh Intake (Remove and Replace)을(를) 참조하십시오.
- 후드 내 보관 유닛을 장착합니다. Underhood Storage Unit (Remove and Replace)을(를) 참조하십시오.