2024-08-27

Seat Back - 2nd Row - RH (Remove and Replace)

Correction code 13054102 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications: Seat Back - 2nd Row - RH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
RH 시트 등받이 힌지 브래킷을 차체에 고정하는 너트
18 Nm (13.3 lbs-ft)
  • 13mm 소켓
  • 4인치 익스텐션
Reuse

Remove

  1. 2열 하단 시트 쿠션을 탈거합니다. 참조 항목: Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. RH 2열 시트 사이드 볼스터를 탈거합니다. 참조 항목: Bolster - Side - Seat - 2nd Row - LH (Remove and Replace).
  3. 볼스터 브래킷을 고정하는 클립을 분리한 다음 차량에서 브래킷을 탈거합니다.
  4. RH 2열 시트 등받이 어셈블리의 열선 시트 커넥터에서 전기 하네스를 연결 해제합니다(장착된 경우).
  5. RH 시트 등받이 힌지 브래킷을 차체에 고정하는 너트를 탈거합니다.
    18 Nm (13.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    참고
    Use of the following tool(s) is recommended:
    • 13mm 소켓
    • 4인치 익스텐션
  6. RH 시트 등받이 어셈블리의 우측을 위로 들어 올리고 전방과 오른쪽으로 움직인 다음, LH 시트 등받이 어셈블리 밖으로 내측 피벗을 당깁니다.
  7. 차량에서 RH 2열 시트 등받이를 탈거합니다.

Install

Installation procedure is the reverse of removal.