2025-01-17

Noise Absorber - Motor Bay - Front (Remove and Replace)

Correction code 12010102 2.76 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 1133569-00-A 플라이어, 클립 탈거
  • 2025-01-08: LH 전면 도어 하네스 링크를 메인 전면 하네스에 업데이트하고, 명확성을 위해 커넥터 이미지를 추가했습니다.

Remove

  1. 브레이크 부스터를 탈거합니다. 참조 항목: Electromechanical Brake Booster Assembly (Non-Heat Pump) (LHD) (Remove & Replace).
  2. 윈드실드 워셔액 저장 탱크를 탈거합니다. 참조 항목: Reservoir - Windshield Washer (Remove and Replace).
  3. 스티어링 컬럼 제어 모듈(SCCM)을 탈거합니다. 참조 항목: Module - Steering Column Control (Remove and Replace).
  4. 차량 컴퓨터에서 냉각수 호스를 분리합니다. 참조 항목: GUID-994B4C5E-5DBE-4BAB-A037-D142FE9AF2FF.html.
  5. 오른쪽 차체 컨트롤러에서 검은색 커넥터를 분리하고 연결 해제합니다. 참조 항목: GUID-514D8D56-A8EC-47C0-8BE1-D862251DB817.html.
  6. 차량에서 전면 대시보드 흡음재를 탈거합니다.

Install

  1. 차량에서 전면 대시보드 흡음재를 장착합니다.
  2. 오른쪽 차체 컨트롤러에서 검은색 커넥터를 연결하고 연결 해제합니다. 참조 항목: Harness - Door - Front - LH (Remove and Replace).
  3. 차량 컴퓨터에서 냉각수 호스를 연결합니다. 참조 항목: GUID-994B4C5E-5DBE-4BAB-A037-D142FE9AF2FF.html.
  4. 스티어링 컬럼 제어 모듈(SCCM)을 장착합니다. 참조 항목: Module - Steering Column Control (Remove and Replace).
  5. 윈드실드 워셔액 저장 탱크를 장착합니다. 참조 항목: Reservoir - Windshield Washer (Remove and Replace).
  6. 브레이크 부스터를 장착합니다. 참조 항목: Electromechanical Brake Booster Assembly (Non-Heat Pump) (LHD) (Remove & Replace).