2023-08-03

Trim - A-Pillar - Upper - LH (Remove and Replace)

Correction code 15184002 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2023-07-06: 탈거 부분의 5단계에 비디오를 추가했습니다.

Remove

  1. LH 전면 도어를 엽니다.
  2. LH 계기판 엔드캡을 탈거합니다. End Cap - Instrument Panel - LH (Remove and Replace)을(를) 참조하십시오.
  3. LH 중간 A필러 트림을 탈거합니다. Trim - A-Pillar - Middle - LH (Remove and Replace)을(를) 참조하십시오.
  4. LH 상단 A필러 트림을 A필러에 고정하는 클립을 분리합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    가장 위쪽 클립을 먼저 풀고 앞뒤로 작업합니다.
  5. LH 상단 A필러 트림에서 테더 후크(3개)를 비틀어 당겨 LH 상단 A필러 트림 테더를 분리합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    차체 측면에서 LH 상단 A필러 트림 테더를 탈거하지 마십시오. 차체에서 테더를 탈거할 경우, 테더를 교체해야 합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  6. 위쪽으로 당겨 차량에서 LH 상단 A필러 트림을 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    나머지 LH 상단 A필러 트림 클립을 LH A필러에서 모두 탈거하고, 나중에 LH 상단 A필러 트림을 장착하는 경우 트림에서 모든 클립을 탈거합니다.

Install

  1. 같은 LH 상단 A필러 트림을 재사용하는 경우 새 클립을 트림에 장착합니다.
  2. 클립이 손상되지 않았으며 트림에서 올바른 위치에 장착했는지 확인합니다.
  3. 테더 후크(3개)를 LH 상단 A필러 트림에 조입니다.
  4. 트림의 전면 하부 가장자리를 계기판 캐리어에 끼운 다음, LH 상단 A필러 트림을 A필러에 고정하는 클립을 단단히 조입니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    먼저 상단 클립을 조인 다음, 차량 앞쪽을 향해 작업합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    차량 외부에서 윈드실드를 통해 육안으로 LH 상단 A필러 트림이 A필러와 편평한지 확인합니다.
  5. 기본 전면 사이드 차체 씰을 LH 상단 A필러 트림으로 당깁니다.
  6. LH 중간 A필러 트림을 장착합니다. Trim - A-Pillar - Middle - LH (Remove and Replace)을(를) 참조하십시오.
  7. LH 계기판 엔드캡을 장착합니다. End Cap - Instrument Panel - LH (Remove and Replace)을(를) 참조하십시오.