2019-08-13

Brake Lines - Rear - LH to Sill (Remove and Replace)

Correction code 33035202 0.96 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 1079041-00-A 플레어 너트 크로우풋 세트

Remove

  1. Warning IconA warning icon, calling your attention to a possibly risky situation
    경고

    Brake fluid dissolves paint. Have clean towels and plenty of water standing by to wash spilled brake fluid off painted surfaces.

    Informational PurposesAn informational icon, calling your attention
    참고

    사용한 브레이크 오일은 현지 환경 규정에 따라 폐기합니다.

  2. LH 후면 휠 아치 라이너를 탈거합니다. Wheel Arch Liner - Rear - LH (Remove and Replace)을(를) 참조하십시오.
  3. 브레이크 라인 정션 블록 아래에 오일 배출 용기를 배치합니다.
  4. 정션 블록에서 브레이크 라인 튜브 너트를 탈거하고 오일을 배출합니다.
  5. 후면 LH 브레이크 호스 아래에 오일 배출 용기를 배치합니다.
  6. 자운스 호스 브래킷의 브레이크 호스에서 브레이크 라인 튜브 너트를 탈거하여 오일을 배출합니다.
  7. 브레이크 라인을 차체에 부착하는 클립을 푼 다음 차량에서 브레이크 라인을 탈거합니다.

Install

  1. 브레이크 라인을 차체에 장착한 후 브레이크 라인을 차체에 고정하는 클립을 조입니다.
  2. 자운스 호스 브래킷의 브레이크 호스에 브레이크 라인을 삽입한 후 크로우풋 익스텐션을 사용하여 브레이크 라인 튜브 너트를 브레이크 호스에 장착합니다.
    16 Nm (11.8 lbs-ft)
  3. 브레이크 라인을 정션 블록에 장착한 후 크로우풋 익스텐션을 사용하여 브레이크 라인 튜브 너트를 정션 블록에 장착합니다.
    16 Nm (11.8 lbs-ft)
  4. 후면 LH 캘리퍼에 대해 브레이크 라인을 블리딩합니다. 참조 항목: Brake Fluid Bleed - One Caliper.
  5. LH 후면 휠 아치 라이너를 장착합니다. Wheel Arch Liner - Rear - LH (Remove and Replace)을(를) 참조하십시오.