2024-06-11

Gap Hider - Steering Column - Lower (Remove and Replace)

Correction code 140500220.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. LH 전면 도어를 열고 창문을 완전히 내립니다.
  2. 후면 후드 내 에이프런을 탈거합니다. 참조 항목: Underhood Apron - Rear (Remove and Replace).
  3. 12V 전원을 연결 해제합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
  4. 운전석 에어백을 탈거합니다. 참조 항목: Airbag - Driver (Remove and Replace).
  5. 스티어링 휠을 탈거합니다. 참조 항목: Steering Wheel (Remove and Install).
  6. 스티어링 컬럼 상단 슈라우드를 탈거합니다. 참조 Shroud - Upper - Steering Column (Remove and Replace)
  7. 스티어링 컬럼 하단 슈라우드를 탈거합니다. 참조 Shroud - Lower - Steering Column (Remove and Replace)
  8. LH 발밑 공간 커버를 탈거합니다. 참조 항목: Cover - Footwell - Driver (Remove and Replace).
  9. 운전석 무릎 에어백을 탈거합니다. 참조 항목: Airbag - Knee - Driver (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    참고
    무릎 에어백은 미국 판매용 차량에만 장착됩니다.
  10. 계기판 서브 어셈블리에서 하단 스티어링 컬럼 갭 하이더를 고정하는 클립을 분리합니다.
  11. 차량에서 하단 스티어링 컬럼 갭 하이더를 탈거합니다.

Install

Installation procedure is the reverse of removal.