2024-11-14

Camera - Interior (Remove and Replace)

Correction code 17241602 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2024-11-01: 교체 카메라를 연결하기 전에 정비 모드를 활성화해야 한다는 참고 사항을 추가했습니다.

Remove

  1. 리어 뷰 미러를 탈거합니다. 참조 항목: Mirror - Rear View (Remove and Replace).
  2. 상단 쿼드 카메라 커버를 고정하는 클립을 분리하고 탑승자 카메라 커넥터를 연결 해제한 다음 차량에서 카메라 커버를 탈거합니다.
  3. 탑승자 카메라를 상단 쿼드 카메라 커버에 고정하는 탭(3개)을 분리하고 카메라에서 전기 하네스(장착된 경우)를 분리한 다음 카메라 커버에서 카메라를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    탭이 한 개 이상 손상되는 경우 카메라를 나사로 고정할 수 있습니다(토크 1Nm).
    그림 1. 기존 카메라 유형
    그림 2. 새 카메라 유형
    그림 3. 기존 카메라 유형
    그림 4. 새 카메라 유형

Install

  1. 정비 모드를 활성화합니다. 참조 항목: Service Mode.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    교체용 카메라의 잠재적 손상을 방지하기 위해, 카메라를 연결하기 전에 반드시 정비 모드를 활성화해야 합니다.
  2. 탈거의 역순으로 진행하여 교체용 실내 카메라를 장착합니다.
  3. 터치스크린을 사용하여 차량 DAS를 초기화합니다. Service Mode "렌치" > Driver Assist > Cameras > Reset DAS
  4. 정비 모드를 비활성화합니다. 참조 항목: Service Mode.