Beam - 12V Battery (Dual Motor) (Remove and Replace)
Correction code
17012712
1.56
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 2열 하단 시트 쿠션을 탈거합니다. Seat Cushion - Lower - 2nd Row (Remove and Replace)을(를) 참조하십시오.
- 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
- 실내 흡기 덕트를 탈거합니다. 덕트 - 상단 - 실내 흡기(탈거 및 교체)을(를) 참조하십시오.
- 후드 내 보관 유닛을 탈거합니다. Underhood Storage Unit (Remove and Replace)을(를) 참조하십시오.
- LH 및 RH 와이퍼 암을 탈거합니다. Wiper Arms (Remove and Replace)을(를) 참조하십시오.
- LH 및 RH 쇼크 타워 커버를 탈거합니다. Cover - Shock Tower - LH (Remove and Replace)을(를) 참조하십시오.
- 카울 스크린 패널을 탈거합니다. Panel - Cowl Screen (Remove and Replace)을(를) 참조하십시오.
- 12V 전원을 연결 해제합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
- 12V 보조 배터리를 탈거합니다. 12V/LV Battery (Remove and Replace)을(를) 참조하십시오.
- 전면 차체 컨트롤러 모듈을 탈거합니다. Module - Body Controller - Front (Dual Motor) (Non-Heat Pump) (Remove and Replace)을(를) 참조하십시오.
-
냉각수 호스와 전기 하네스를 12V 배터리 빔에 고정하는 클립을 분리합니다.
-
12V 배터리 빔을 차량에 고정시키는 볼트를 분리합니다.9 Nm (6.6 lbs-ft)
-
12V 배터리 브래킷과 12V 배터리 빔을 차량에서 탈거합니다.
참고빔을 차량 RH 쪽으로 조심해서 민 후 빔의 LH 쪽을 들어 어셈블리를 탈거합니다.
-
12V 배터리 빔을 12V 배터리 브래킷에 고정하는 볼트를 분리한 후 브래킷을 치워 둡니다.9 Nm (6.6 lbs-ft)
Install
Installation procedure is the reverse of removal, except for the following:
- Replace all nyloc nuts.
- Replace all patchbolts.