2024-09-25

Antenna - GPS (Remove and Replace)

Correction code 21320102 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2024-09-12: 트리플 카메라 어셈블리에서 하네스를 연결 해제하지 않아도 된다는 참고 사항을 추가했습니다.

Remove

  1. 전방 카메라를 탈거합니다. 참조 항목: Camera - Triple - Forward Facing (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    참고
    트리플 카메라 어셈블리에서 전기 하네스를 연결 해제하지 않아도 됩니다. 트리플 카메라 어셈블리를 차량에 고정하는 패스너를 탈거한 다음 어셈블리를 하네스에 매달아 둡니다.
  2. 습도 및 온도 센서 커넥터에서 전기 하네스를 연결 해제합니다.
  3. GPS 안테나 커넥터에서 전기 하네스를 연결 해제합니다.
  4. 전기 하네스를 윈드실드 브래킷에 고정하는 나사를 탈거한 다음 전기 하네스를 한쪽으로 치워둡니다.
    1 Nm (.7 lbs-ft)
  5. GPS 안테나를 브래킷에 고정하는 나사를 탈거한 다음 차량에서 GPS 안테나를 탈거합니다.
    1 Nm (.7 lbs-ft)

Install

Installation procedure is the reverse of removal, except for the following: