2025-09-23

Sensor - Parking Distance - Inner - Front (Remove and Replace)

Correction code 17271012 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Informational PurposesAn informational icon, calling your attention
참고
내측 주차 거리 센서는 S3 및 S4입니다. 외측 주차 거리 센서는 S1, S2, S5 및 S6입니다. 참조 항목: Sensor - Parking Distance - Outer - Front (Remove and Replace)
Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  • 2023-04-28: 보충 목적 전용으로 전체 절차 비디오를 개요로 추가했습니다.

Install

  1. 주차 센서를 전면 페시아에 장착한 다음 전면 주차 거리 센서를 전면 페시아에 고정하는 탭(2개)을 조입니다.
  2. 후드 내 보관 유닛을 장착합니다. 참조 항목: Underhood Storage Unit (Remove and Replace).
  3. 실내 흡기 덕트를 장착합니다. 참조 항목: 덕트 - 상단 - 실내 흡기(탈거 및 교체).
  4. 후면 후드 내 에이프런을 장착합니다. 참조 항목: Underhood Apron - Rear (Remove and Replace).
  5. 부품 카탈로그를 참조하여 차량에 장착된 주차 센서 유형을 확인합니다. 차량에 Tesla USS가 장착된 경우 다음 Toolbox 3.0 루틴을 나열된 순서대로 실행합니다.
    1. TEST-RESET_PARKvia Toolbox: (link)
    2. PROC_USM_FRONT_PROGRAM-USS-ADDRESSESvia Toolbox: (link)via Service Mode: Driver Assist ➜ Sensors ➜ Program Front USS